Tube Spider Includes S&H

Tube Spider

IT GIVES YOU THE RIGHT BITE EVERY TIME!
Circular Profile Gage for the perfect Notch. Made from aircraft aluminum with stainless steel pins. Thumb screw for positive positioning on tubing.

DIRECTIONS:
1. Push all the pins flush with the body of the TS.
2. Install TS on end of tube. *
3. Push pins forward slowly, one at a time, to get an accurate contact.
4. Slide the TS back on the tube to be cut and use marker to connect the dots.
(Like the kid's game!)
5. Use your choice of cutting tool to follow the marker line.

NO! NO! The pins are long & small in diameter to get into extremely tight places. Do NOT try and use this like a dagger! The pins will distort and you will not get the accuracy that you need. If you DO bend the pins or break the retention o-rings, stainless tig rod and a visit to the parts store will provide replacement parts.

*On a long span, clamp a piece of mig wire or a straight edge to extend your reach.

ALL SIZES LISTED ARE TUBING SIZES!!! Pipe Sizes by Special Order.